How to monitor details in real time during dispensing machine operation

Sep 05, 2025 Leave a message

How to monitor details in real time during dispensing machine operation


Glue status: Check the cartridge liquid level every 15-30 minutes (for two-component glue, monitor the A/B glue consumption rates simultaneously. If there is a large difference, the valve may be clogged). Observe whether the glue discharge is continuous (if the glue discharge is intermittent, check for air pressure fluctuations or air ingress into the cartridge).


Device operation: Observe whether the needle moves smoothly (no sticking or unusual noises. If there are unusual noises, it may be due to lack of lubricant in the guide rails; stop the machine and add lubricant). Observe whether the Z-axis is fully raised (no collisions when avoiding the fixture. If there are collisions, immediately press the emergency stop button and check the avoidance height parameter).


Personnel safety: Do not reach into the machine's motion area (especially the X/Y axis range) during operation. Do not remove the needle or cartridge while the machine is running (pause the program and turn off the air supply first). If you need to adjust parameters, you must first pause the machine to avoid coordinate distortion caused by "modifying while running."

Send Inquiry

whatsapp

Phone

E-mail

Inquiry