There are various reasons for uneven silicone ink print thickness. For ink, it is due to poor ink mixing, or the normally mixed ink is mixed with ink skin. When printing, it swells and softens due to the action of the solvent, blocking the mesh holes that should be permeable to ink, acting as a plate film and preventing the ink from passing through.
In order to prevent this kind of failure, the mixed silicone ink (especially the old ink) should be filtered once with a net before use. When reusing the used printing plate, the old ink attached to the plate frame must be completely removed. When storing the printing plate after printing, it must be fully washed (including the scraper). If the above requirements are followed, the uneven silicone ink will not occur.
If the tip of the front end of the sharp plate is damaged, there will be traces along the direction of movement of the scraper. Especially when printing transparent objects, there will be obvious uneven ink. Therefore, the front end of the sharp plate must be well protected to prevent it from being damaged. If it is damaged, it must be carefully ground with a grinder.
The unevenness of the printing table will also affect the uniformity of silicone ink. The ink layer is thin on the convex part and thick on the concave part. This phenomenon is also called uneven ink application. In addition, if there is dust on the back of the substrate or on the printing table, the above fault will also occur.


