Impact of PVC and Silicone Material Properties on the Dispensing Process 2
Dispensing Equipment and Parameter Differences
Equipment Selection
PVC: Due to its high viscosity and the need for heating assistance, high-pressure dispensing valves (such as plunger valves) or screw dispensers are often used, along with heated barrels to prevent material solidification and ensure continuous dispensing.
Silicone: Low-viscosity silicone can be dispensed with pneumatic dispensing valves or jet dispensers; high-viscosity or two-component silicone requires a static mixer (to ensure uniform mixing of the A/B adhesives), and some require a vacuum degassing device (to prevent bubbles after curing).
Parameter Settings
PVC: High dispensing pressure is required (to cope with high viscosity), slow dispensing speed is required (to avoid splashing), and baking temperature and time are strictly controlled (to prevent over-baking, discoloration, or under-curing).
Silicone: Two-component silicone requires precise control of the A/B adhesive ratio (e.g., 1:1, 10:1). Dispensing pressure and speed are adjusted according to viscosity. Curing temperature (e.g., room temperature 25°C or heated 60°C) affects curing efficiency, but requires higher precision (to avoid curing failure due to incorrect ratios).
Impact of PVC and Silicone Material Properties on the Dispensing Process 2
Aug 12, 2025 Leave a message
Send Inquiry

