How to use silk screen flocking silicone?

Sep 10, 2025 Leave a message

Silk screen flocking silicone is a material commonly used in screen printing to create textured, velvety, or raised designs on fabric or other surfaces. It combines silicone with flocking fibers to achieve a durable, soft-touch finish. Below are the steps to use it effectively:


Materials Needed

Silk screen flocking silicone.

Screen printing frame with an appropriate mesh count (around 70–120 mesh).

Flocking fibers (if applicable for a velvety finish).

Silicone squeegee.

Heat press or curing equipment.

Textile substrate (e.g., fabric, t-shirt).

Mixing tools (if the silicone requires catalyst or pigment addition).

Masking tape or clamps.


Step-by-Step Guide

1. Prepare the Screen and Design

Choose a stencil/design: Use a pre-made or custom stencil that matches the design you want to print.

Set up the screen: Secure the silk screen frame tightly with the substrate (fabric or other materials) underneath it.

Mask off areas of the screen that you don't want to print on using masking tape.

2. Prepare the Flocking Silicone

Mix the silicone: If required, add any pigments, catalysts, or hardeners to the silicone as per the manufacturer's instructions. Mix thoroughly to ensure even consistency.

Test the viscosity: The silicone should be smooth but not too runny, as this can affect the print quality.

3. Apply the Silicone

Spread the silicone: Place a small amount of the flocking silicone on one side of the screen.

Use a squeegee: Pull the silicone across the screen using firm, even pressure. Repeat if necessary to ensure the design is fully covered.

Check that the silicone is evenly deposited without gaps or smudging.

4. Apply Flocking Fibers (Optional)

If using flocking fibers for a velvety texture:

Sprinkle the fibers evenly over the wet silicone layer while it's still tacky.

Use a flocking machine for a more consistent result or manually apply the fibers.

Gently press the fibers into the silicone to ensure adhesion.

5. Curing the Silicone

Allow the silicone and fibers to cure. This can be done by:

Air drying: Let the item dry naturally (time depends on the silicone used).

Heat curing: Use a heat press or curing oven at the temperature recommended by the silicone manufacturer (usually 150–180°C for 1–3 minutes).

Ensure the silicone is fully cured before handling.

6. Clean Up

Clean the screen, squeegee, and other tools immediately using appropriate cleaners (e.g., silicone solvent or water-based cleaner) to prevent silicone from hardening on them.


Tips for Best Results

Mesh count: Use a mesh count that matches the viscosity of your silicone. A lower mesh count works well for thicker silicones.

Test the process: Always test on a sample to ensure proper adhesion, texture, and curing.

Even application: Maintain consistent pressure on the squeegee to avoid uneven prints.

Heat settings: Follow the silicone manufacturer's heat curing recommendations closely to avoid under- or over-curing.


By following these steps, you can achieve professional-quality flocking silicone prints with a durable, textured finish!

Send Inquiry

whatsapp

Phone

E-mail

Inquiry