First clean the components to be glued to remove the oil on the surface, then squeeze the product out of the metal hose and apply it to the surface of the components. Cured into an elastomer.
When using, the adhesive layer must be fully exposed to the air. The larger the contact area, the faster the curing, and vice versa, it will be slower or even not cured.
The thicker the adhesive layer, the longer the curing time, the higher the humidity and temperature in the same environment, the faster the curing speed of the adhesive layer. The opposite is true.
After the product is used, the hose should be tightly capped immediately so that it can be stored and used again.
For automatic production lines, a pneumatic dispenser can be used to apply glue.